Replacing Bulb Without Dismounting Lighting Device - Dometic EA 3080 Service Manual

- Install lighting device, with attention to the placement of electrical wires.
(Figure 57)
Figure 56
- Fastening securing screws. Make sure it fits correctly. The must be no gap
between the lighting device and the inner compartment.
2.3.2. Replacing bulb without dismounting the lighting device
- By pushing the reflector plate unhinge blocking tab on reflector from the
light shield. At the same time, push the light shield off of the casing with a
screwdriver. (Figure 58)
- Unscrew defective bulb and replace with a new one; pay attention to
appropriate back-up power. Bulb needs to be tightened to an extent that
loose connection does not cause contact failure. (Figure 59)
- Replacing the light shield. Make sure the groove fits correctly on the light
shield. (Figure 60)
The light shield can be slid in place by slightly pressing the blocking tab
with a screwdriver.
Figure 58
Figure 57
Figure 59
17
Figure 60