2.3.3. Replacing heating element (cylindrical heating element) :
-
Remove screws of electrical cover. (Figure 61)
-
Remove electrical cover. (Figure 62)
-
Pop out locking tabs of the base with a screwdriver, lift off printed circuit
board. (Figure 63)
Figure 61
-
Push off flat socket of heating element from flat connector with a
screwdriver (x3 connector). (Figure 64)
-
Push off flat socket of the heating element's protective grounding with a
screwdriver while the protective tab is pressed. (Figure 65)
-
Spread the the temperature controller connection of the heating element.
(Figure 66)
-
Unscrew and remove the wire clamp. (Figure 67)
Figure 64
Figure 66
Figure 62
Figure 65
Figure 67
18
Figure 63