Manual Scan; Factory Reset - AerialBox T2200 User Manual

Installation
3. Enter in the Frequency number.
4. Choose the correct bandwidth.
5. Select your scan mode, you can
choose wither FTA or Scrambled or
both.
6. Press the Green button to begin the
manual scan. Or if you wish to reset
the manual tune then press the
Yellow button and start again.

Factory Reset

In the unlikely event that the unit has
issues or you are having a hard time
trying to use the T2200 unit, then a
Factory Reset should be able to correct
any issues.
Press Menu > Installation then
1.
Factory Reset
2. Confirm that you would like to
complete a Factory Reset.
3. Enter in your PIN number (default is
0000)
4. Wait a few minutes for the unit to
reset back to the default settings.
You will then be asked to go
through the initial set up again.
Having Issues?
If you are having trouble with the Factory Reset or your unit continues
to have the same issues then please contact us. Make sure you are
very descriptive with the issue and note of any actions you have done
to try and resolve.
38
A Factory Reset will wipe away all
settings except recorded shows
on the Hard Drive.