Canyon Urban Manual page 12

20 ASSEMBLY FROM THE BIKEGUARD
Position the fork and the stem in direction of motion.
Unscrew the clamping bolts of the faceplate com-
pletely.
Remove the faceplate.
Position the stem clamp in the middle of your new
Canyon handlebars so that the handlebars extend
the same distance from the stem on each side. The
centre position is indicated with the marks on the
handlebars.
Make sure the bowden cables and the lines are not
twisted or bent, but run in a smooth curve to the cable
stops or brakes.
If the handlebars do not slide easily into the stem
clamp or if there is play between the two compo-
nents, contact the Canyon service hotline at +44 208
5496001 and ask whether both components are com-
patible.
Tighten the greased bolts of the stem faceplate with
your fingers by a few turns. Do not apply grease on
the clamping surfaces.
Turn in the individual bolts of Canyon stems with a
precisely fitting Allen key by a few turns. Then turn in
only the two upper bolts until the upper clamping slot
is completely closed.
Screw in both upper bolts (pos. 1+3) without tight-
ening them (1 Nm). The slot should be fully closed in
the end, the faceplate should be flush with the body.
To do so, you may have to release both lower bolts
(pos. 4+2) a little.
ASSEMBLY FROM THE BIKEGUARD
1 3
4 2
Continue by tightening both lower bolts (pos. 4+2)
according to the torque values on the stem (5 or
8 Nm).
Finish by re-tightening both upper bolts (pos. 1+3)
according to the torque values on the stem.
Check whether the clamping slots between face-
plate and stem body are parallel. The upper
slot must be closed, the lower slot is then a little
opened. Release the clamping bolts once again, if
necessary, and re-tighten them slightly and evenly
according to the indicated values.
At this stage the Urban bike is not yet
ready-for-use. Carry out the final adjust-
ment and check of the handlebars.
21