Canyon Urban Manual page 9

14 ASSEMBLY FROM THE BIKEGUARD
It also retains its effectiveness in wet conditions and
provides maximum protection against corrosion.
Canyon assembly paste can be used for all carbon
and aluminium connections. It's ideal for this pur-
pose, as it does not harden.
Make it a rule to use assembly paste on
i
seat posts of Urban bikes to achieve a firm
seat of the seat posts. If the height of the seat
post is often changed, the surface is at risk of be-
ing scratched. This is normal wear and no reason
for complaint.
Prior to applying Canyon assembly paste, remove dirt
particles and lubricant residues from the surfaces to
be treated. Apply a thin and even film of Canyon as-
sembly paste to the cleaned surfaces using a brush
or a chamois.
Mount the components, as specified.
Use the Canyon torque wrench and never exceed the
prescribed maximum torque value. Remove excessive
Canyon assembly paste and re-seal the small sachet
after use.
UNPACKING
Take out the box with the small parts and put it aside.
Remove the protective cardboard, if available.
Remove the toolcase with the bicycle manual Urban
and the tools from the small parts box.
Make sure the saddle and the seat post
i
are fastened to the frame.
Keep the entire packaging material as well
i
as the BikeGuard in a dry place. If you in-
tend to ship your Canyon or to take it with you on
a trip, you will have everything at hand.
ASSEMBLY FROM THE BIKEGUARD
Carefully lift the frame to which the front wheel as
well as the saddle and the seat post are fastened
together with the components and the mounted rear
wheel out of the BikeGuard.
Safely place down the partly assembled Urban bike
with the triangular wheel support cardboard. Ask
your helper, if necessary, to hold the bike.
When lifting out the frame, hold tight the
!
front wheel as well as the saddle and the
seat post to make sure they do not fall down and
get damaged.
15