Canyon Urban Manual page 11

18 ASSEMBLY FROM THE BIKEGUARD
MOUNTING THE HANDLEBARS
Mounting the handlebars to the Canyon Commuter
(Canyon H18 Flat Extensions)
Hold both fixed handlebar extensions tight. Start by
undoing the band with Velcro fastener fastening the
right-hand handlebar extension to the fork.
Undo the band with Velcro fastener fastening the left-
hand handlebar extension to the top tube.
The fork is fixed by means of the headset itself and
cannot slip out.
In packed condition the handlebars are
not assembled, the stem is however as-
sembled accurately. Do not make any changes to
the stem.
Slide the right-hand handlebar extension on the
handle bar/stem combination.
Slide the left-hand handlebar extension on the han-
dlebar/stem combination.
Make sure the bowden cables and the
!
lines are not twisted or bent, but run in a
smooth curve to the cable stops or brakes.
Take the bag with the four handlebar bolts out of the
small parts box.
Take the Canyon torque wrench and put the bit match-
ing the handlebar bolts into the holder.
Slightly tighten the two handlebar bolts evenly on
each bottom side of the handlebar by using the
Canyon torque wrench to a maximum torque of 4 Nm.
Do not exceed the maximum torque values!
At this stage the Urban bike is not yet
ready-for-use. Carry out the final adjust-
ment and check of the handlebars.
ASSEMBLY FROM THE BIKEGUARD
Mounting the handlebars to the Canyon Urban
(Canyon H27 Flat AL)
Hold the flat handlebars which are fastened to the
fork tight and undo the band with Velcro fastener
which is fastened to the top tube.
Undo the band with Velcro fastener in the bottom
area of the fork. Hold the handlebars tight while doing
this so that they cannot drop and get damaged.
Take the Canyon torque wrench and put the bit
matching the faceplate bolts into the holder.
19