WhisperKool SLIMLINE 2500 Owner's Manual

Hide thumbs Also See for SLIMLINE 2500:

Advertisement

Quick Links

SLIMLINE 2500
OWNER'S MANUAL
WINE CELLAR
I
N
T
E
R
N
A
T
I
O
N
A
L
Exclusive dealer of
The Coolest Thing In Wine Storage

Advertisement

Table of Contents
loading

Summary of Contents for WhisperKool SLIMLINE 2500

  • Page 1 SLIMLINE 2500 OWNER’S MANUAL WINE CELLAR Exclusive dealer of The Coolest Thing In Wine Storage...
  • Page 2 Vinothèque Wine Cellars reserves the right to make corrections or improvements to the information provided and to the related hardware at any time, without notice. Vinothèque and WhisperKOOL are registered trademarks, and ECE is a trademark of Vinothèque Wine Cellars. All rights re- served.
  • Page 3: Table Of Contents

    TABLE OF CONTENTS Quick Reference Guide Unit ............
  • Page 4: Quick Reference Guide

    QUICK REFERENCE GUIDE Front / Side View (in cellar / evaporator) Bottle Probe Grille Probe Input Controller Power Cord Drain Port Bottom View Rear / Side View (out of cellar / condenser) Probe Input Power Cord Grille Page 2 SL 082411...
  • Page 5 QUICK REFERENCE GUIDE Note: Refer to page 15 for complete listing of buttons and symbols. Compressor and Condenser Fan Evaporator rost Cellar “Pre-Chill” Bu on Energy Saving Bu on Hi Bo le Temp History & Scroll Bu on Energ Push to see the max stored temperature. In programming mode use to browse the parameter codes or increase the display Set Bu on...
  • Page 6: Introduction

    Customer Service Thank you for purchasing a WhisperKOOL Slimline cooling unit. We strive to provide the highest quality products and the best possible customer service. If you have any questions about your WhisperKOOL unit, please call us at 1(800) 343-9463.
  • Page 7: Receiving & Inspecting The Unit

    • Insulation Foam Strips (4) Please leave the WhisperKOOL unit in its original box until you are ready for installation, this will allow you to move the product safely without damaging it. TIP: Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.
  • Page 8: Quick Start Guide

    QUICK START GUIDE This guide is meant to serve as a quick reference for installation of the WhisperKOOL unit. The remainder of this Owner’s Manual will provide more detailed information and instructions. Upon receiving the WhisperKOOL unit: 1. Inspect the unit before installation. If damage is found, please contact your distributor or WhisperKOOL Customer Service at 1.800.343.9463 ext 799.
  • Page 9: Preparing The Wine Cellar

    How to Build a Wine Cellar Instructional Video WhisperKOOL has a construction tutorial available on line at our website: www.whisperkool.com. This tutorial will walk you through the steps of constructing a properly built wine cellar and the installation of our WhisperKOOL product line. Wall & Ceiling Framing Build wine cellar walls using standard 2x4 or 2x6 construction methods and ceiling joists following the guidelines of local and state codes in your area.
  • Page 10 Mounting the Unit down, the warm air will rise to the ceiling. Mounting the WhisperKOOL high in the room will create a consistently cool environment by capturing the warm air and replacing it with cool air. Mounting the unit low in the room will result in a temperature variation in the room due to the unit’s inability to draw warm air from the ceiling of the cellar...
  • Page 11 Thus the drain line will prevent over ow and leaking by allowing for discharge of the additional condensate. WhisperKOOL carries a condensate pump kit, which allows the excess condensate to be pumped up to 20 ft. away from the unit.
  • Page 12: Pre-Installation

    Electrical Needs The WhisperKOOL System requires a dedicated 110-volt 20-amp circuit. The unit draws a large amount of amps at initial start up. By designating a dedicated circuit breaker, you will guarantee the unit has enough power to run ef- fectively.
  • Page 13: Preparing The Installation Location

    Note: The following installation examples are for reference only, door header construction and framing may vary. When not installing above a door, adequate framing inside of the wall is necessary. WhisperKOOL recommends consulting a licensed contractor for framing and construction needs.
  • Page 14: Installation

    Bottle Probe pre drilled holes. The screws should penetrate the studs and/or frame as well as the upper and lower supports to provide adequate support for the WhisperKOOL system. Power Seal all cracks and gaps around the unit with an air-tight sealant or caulking to prevent air leakage.
  • Page 15: Liquid Measuring Thermostat System

    LIQUID MEASURING THERMOSTAT SYSTEM The WhisperKOOL Slimline cooling unit comes equipped with a liquid temperature measuring thermostat system. The probe contains a sensor chip which actually communicates back and forth to the thermostat. This results in a consistent temperature setting and accuracy.
  • Page 16: System Operation

    SYSTEM OPERATION Initial Start-Up Anti Frost Cycle When power is applied to the unit, the control will The Anti Frost Cycle is a precautionary measure, as icing or frosting of the coil does not occur during symbol will be displayed (if unit is calling for cooling). normal operation.
  • Page 17: Control Functions

    CONTROL FUNCTIONS Button/Symbol Normal Functions • ON/OFF The ON/OFF button allows the customer the convenience of turning the refrigeration system ON or OFF, from the control panel. This feature does not disconnect power from unplugged from the wall receptacle. • Press the ON/OFF button once for button application.
  • Page 18 SET 1. Press the “Set” button once and it will display the Set Point. After approximately 5 sec- onds, the display will return to normal operation and display the Bottle Probe tempera- ture. 2. Standard Controller - Press and hold the “Set” button for 3-5 seconds until the set point is displayed and the °F symbol starts blinking.
  • Page 19 CPSM Mode Press the “Set” and the “Down Arrow” buttons simultaneously, for 10-15 seconds, and you will access the “Customer Preference Selection Mode” (CPSM). The CPSM allows the customer to “Fine Tune” the Control Operating System to their applicable choice. The following CPSM options are available for adjustment: Fon –...
  • Page 20: Maintenance Schedule

    MAINTENANCE SCHEDULE It is the user’s responsibility to remove any accumulated dust, lint, or other debris from the front and rear intake free of debris and mold to maintain proper performance. Monthly 1. Check for unusual noise or vibration 2. Check the drainline to see if it is above the waterline if draining into a vessel. Quarterly 1.
  • Page 21: Troubleshooting Guide

    TROUBLESHOOTING GUIDE Unit has ice forming on the evaporator Possible Cause Solution Clean coil with a vacuum. Evaporator coil is dirty. If coil is very dirty, use a small hand spray with a small amount of liquid dish washer detergent. Spray coil, let set for 5 min, then Remove blockage There is something blocking the supply and or return air Call a service tech to troubleshoot...
  • Page 22: Compressor Short Cycles

    TROUBLESHOOTING GUIDE Unit leaks water Possible Cause Solution Unit is not level Unit should be level in wall to prevent leaking Drain line clogged or kinked Drain is clogged preventing water form escaping Disconnect drain and clear out Drain line does not have a downward slope Fix Drain line so there is a downward slope from the unit to the drain.
  • Page 23: Technical Assistance & Accessories

    Fax (209) 466-4606 ACCESSORIES FOR COOLING UNITS WhisperKOOL o ers accessories to enhance and customize your Slimline wine cooling unit. ThruWall Room to Room Fan The ThruWall™ Room to Room Fan balances temperatures in adjoining rooms by transfering warm air out of exhaust room quietly and e ciently.
  • Page 24: Installation Terms And Conditions

    A. Two (2) Year Limited Warranty. For the period of TWO (2) YEARS (the “Limited Warranty Period”) from the date of original sale of a Product by WhisperKOOL, if a WhisperKOOL Product is found to be defective in material or workmanship after undergoing WhisperKOOL’s customer service troubleshooting, then, subject to the WhisperKOOL Product Limited Warranty Limitations and Exclusions as well as the other Terms and Conditions stated herein, WhisperKOOL will do the following, as appropriate, for the end user (“End User”) who has...
  • Page 25 (5) Proof of purchase of the Product in the form of a bill of sale or receipted invoice, which is evidence that the Product is within the Limited Warranty Period, must be presented by the End User to WhisperKOOL in order to obtain limited warranty service.
  • Page 26 WhisperKOOL, Purchaser and End User, hereby irrevocably submit to the personal jurisdiction of such courts for that purpose. No waiver by WhisperKOOL of any breach or default of the contract of sale (including these Terms and Conditions) concerning a Product will be deemed to be a waiver of any preceding or subsequent breach or default.
  • Page 27 NOTES...
  • Page 28 WINE CELLAR Exclusive dealer of WhisperKOOL 1738 E. Alpine Ave Stockton, CA 95205 1(800) 343-9463 www.whisperkool.com...

Table of Contents