Table of Contents
Advertisement
Programming HomeLink
®
✽ ✽ NOTICE
• When programming a garage door
opener, it is advised to park the vehi-
cle outside of the garage.
• It is recommended that a new battery
be placed in the hand-held transmit-
ter of the device being programmed to
HomeLink
®
for quicker training and
accurate transaxle of the radio-fre-
quency signal.
• Some vehicles may require the engine
start/stop button to be turned to the
second (or "accessories") position for
programming and/or operation of
HomeLink.
• In the event that there are still pro-
gramming difficulties or questions
after following the programming steps
listed below, contact HomeLink
www.homelink.com or 1-800-355-
3515.
Standard programming
To train most devices, follow these
instructions:
1. For first-time programming, press and
hold
the
two
HomeLink
®
Channel 1 and Channel 3
Buttons, until the indicator light begins
to flash (after 20 seconds). Release
both buttons. Do not hold the buttons
for longer than 30 seconds.
2. Position the end of your hand-held
transmitter 1-3 inches (2-8 cm) away
from the HomeLink
keeping the indicator light in view.
3. Simultaneously press and hold both
the HomeLink
®
and hand-held trans-
mitter button. DO NOT release the but-
tons until step 4 has been completed.
4. While continuing to hold the buttons
®
at:
the red Indicator Status LED will flash
slowly
and
then
HomeLink
®
successfully trains to the
frequency signal from the hand-held
transmitter. Release both buttons.
5. Press and hold the just-trained
HomeLink
Status Indicator LED. If the indicator
light stays on constantly, programming
is complete and your device should
outside
buttons,
activate when the HomeLink
pressed and released.
6. To
program
HomeLink
through 5.
Rolling code programming
®
buttons while
Rolling code devices which are "code-
protected" and manufactured after 1996
may be determined by the following:
• Reference the device owner's manual
for verification.
• The handheld transmitter appears to
program the HomeLink
Transceiver but does not activate the
rapidly
after
device.
• Press and hold the trained HomeLink
button. The device has the rolling code
feature if the indicator light flashes rap-
idly and then turns solid after 2 sec-
onds.
Features of your vehicle
®
button and observe the red
®
button is
the
remaining
two
®
buttons, follow steps 2
®
Universal
4 35
Advertisement
Table of Contents
