Erasing Homelink® Buttons; Reprogramming A Single Homelink Button - Hyundai 2012 Sonata Hybrid Owner's Manual

Hide thumbs Also See for 2012 Sonata Hybrid:
Table of Contents

Advertisement

Reprogramming a single HomeLink
button
To program a new device to a previously
trained HomeLink
®
button, follow these
steps:
1. Press and hold the desired HomeLink
button. Do NOT release until step 4
has been completed.
2. When the indicator light begins to flash
slowly (after 20 seconds), position the
handheld transmitter 1 to 3 inches
away from the HomeLink
®
surface.
3. Press and hold the handheld transmit-
ter button. The HomeLink
light will flash, first slowly and then rap-
idly.
4. When the indicator light begins to flash
rapidly, release both buttons.
5. Press and hold the just-trained
HomeLink
®
button and observe the red
Status Indicator LED. If the indicator
light stays on constantly, programming
is complete and your new device
should activate.
®
Erasing HomeLink
Individual buttons cannot be erased.
However, to erase all three programmed
buttons:
1. Press
and
®
HomeLink
®
buttons until the indicator
light begins to flash-after 20 seconds.
2. Release both buttons. Do not hold for
longer than 30 seconds.
The Integrated HomeLink
Control System is now in the training
(learn) mode and can be programmed at
any time following the appropriate steps
®
indicator
in the Programming sections above.
®
buttons
FCC ID: NZLZTVHL3
IC: 4112A-ZTVHL3
This device complies with Part 15 of
hold
the
two
outer
the FCC Rules.
Operation is subject to the following two
conditions:
1. this device may not cause harmful
®
Wireless
2. This device must accept any interfer-
The HomeLink transmitter has
been tested and complies with FCC
and Industry Canada rules. P
Changes or modifications not
expressly approved by the party
responsible for compliance could
void the user's authority to operate
the device.
NVS
Nav™ is a trademark of the Gentex
Corporation,
HomeLink
owned
Incorporated, Milwaukee, Wisconsin.
Features of your vehicle
interference, and
ence received, including interference
that may cause undesired operation.
WARNING
®
is a registered trademark and Z-
Zeeland,
Michigan.
®
is a registered trademark
by
Johnson
Controls,
4 37

Advertisement

Table of Contents
loading

Table of Contents