Connecting To A Wired Lan - NEC P502HL User Manual

Connecting to a Wired LAN

The projector comes standard with the Ethernet/HDBaseT port (RJ-45) and the LAN port which provide a LAN con-
nection using a LAN cable.
To use a LAN connection, you are required to set the wired LAN settings on the projector menu. Select [SETUP] →
[INSTALLATION] → [NETWORK SETTINGS]. (→ page 57).
The network settings can also be selected from the APPS menu.
Example of LAN connection
Example of wired LAN connection
NOTE:
• About the projector's Ethernet/HDBaseT and LAN ports
The Ethernet/HDBaseT and LAN ports are the same, aside from the HDBaseT function. To connect to the LAN, use only 1 of the
ports (it is not possible to connect both ports to the LAN).
For controlling the projector by a HDBaseT transmitter whose control signal is not supported (or with which cannot connect the
projector) or over the network, connect to the LAN port. At the same time, for controlling the projector over the network that is
in the state of the NETWORK STANDBY On, connect to the LAN port.
5. Installation and Connections
Server
Hub
80
LAN cable (not supplied)
NOTE: Use a Category 5 or higher
LAN cable.
Ethernet
HDBaseT