NEC P502HL User Manual page 7

Light Module
1. A light module containing multiple laser diodes is equipped in the product as the light source.
2. These laser diodes are sealed in the light module. No maintenance or service is required for the performance of
the light module.
3. End user is not allowed to replace the light module.
4. Contact qualified distributor for light module replacement and further information.
Laser Safety Caution
• The laser module is equipped in this product.
Use of controls or adjustments of procedures other than those specified herein may result in hazardous radiation
exposure.
• This product is classified as Class 1 of IEC60825-1 Third edition 2014-05.
This product is classified as Class 2 of IEC60825-1 Second edition 2007-03. Also complies with FDA performance
standards 21 CFR 1040.10 and 1040.11 for laser products except for deviations pursuant to Laser Notice No. 50,
dated June 24, 2007.
Obey the laws and regulations of your country in relation to the installation and management of the device.
• Blue laser diodes: Wave length 455 nm, Output power 120 W
• Do not look into the lens while the projector is on. Serious damage to your eyes could result. Pay enough attention
to children.
• The below diagram is indicated on the projector.
• Do not look into the light source using optical instruments (such as magnifying glasses and mirrors). Visual impair-
ment could result.
• When turning on the projector, make sure no one within projection range is looking at the lens.
DO NOT STARE INTO THE LENS WHILE IN USE.
v
Important Information