Adjusting The Tilt (Tilt Foot) - NEC P502HL User Manual

Adjusting the tilt (Tilt foot)

Adjusting the left and right tilt.
1. Turn the left and right tilt feet to adjust.
The tilt feet lengthen and shorten when turned.
The height of the projected image is adjusted by turning the left
and right tilt feet.
If the projected image is tilted, turn one of the tilt feet to adjust the
image so that it is level.
• If the projected image is distorted, see "6 Correcting Keystone
Distortion [KEYSTONE]" (→ page 21).
• The tilt feet can be lengthened by a maximum of 20 mm.
• The tilt feet can be used to tilt the projector by a maximum of
4°.
NOTE:
• Do not lengthen the tilt feet any more than 20 mm/0.8". Doing so will make the tilt feet's mount section unstable and could cause
the tilt feet to come off the projector.
• Do not use the tilt feet for any purpose other than adjusting the projector's projection angle.
Handling the tilt feet improperly, such as carrying the projector by grasping the tilt feet or hooking it onto a wall using the tilt feet,
could damage the projector.
2. Projecting an Image (Basic Operation)
Up
Down
20
Tilt foot