Fujitsu ASBA09LGC Operating Manual page 5

Wall mounted type heat & cool model (reverse cycle) indoor/outdoor unit
Table of Contents

Advertisement

Fig. 1 Indoor Unit
1 Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
When kept on pressing the MANUAL AUTO
button for more than 10 seconds, the forced
cooling operation will start.
The forced cooling operation is used at the
time of installation.
Only for authorized service personnel's
use.
When the forced cooling operation starts by
any chance, press the START/STOP button
to stop the operation.
3 Indicator (Fig. 3)
4 Remote Control Signal Receiver
5 OPERATION Indicator Lamp (green)
6 TIMER Indicator Lamp (orange)
If the TIMER indicator lamp fl ashes when the
timer is operating, it indicates that a fault has
occurred with the timer setting (See Page 15
Auto Restart).
7 COIL DRY Indicator Lamp (yellow)
8 Intake Grille (Fig. 4)
9 Fornt Panel
0 Air Filter
A Airfl ow Direction Louver
B Right-Left Louver
(behind Airfl ow Direction Louver)
C Drain Hose
D Power Supply Cord
E Air Cleaning Filter
Fig. 5 Outdoor Unit
F Intake Port
G Outlet Port
H Pipe Unit
I Drain port (bottom)
Fig. 6 Remote Control Unit
J Signal Transmitter
K MODE button
L 10°C HEAT button
M SET TEMP. button (
N COIL DRY button
O SLEEP button
P TIMER MODE button
Q FAN button
R START/STOP button
S ECONOMY button
T SET button
U SWING button
V TIMER SET (
/
) button
W CLOCK ADJUST button
X TEST RUN button
● This button is used when installing the air
conditioner, and should not be used under
normal conditions, as it will cause the indoor
unit's thermostat function to operate incor-
rectly.
● If this button is pressed during normal
operation, the indoor unit will switch to
test operation mode, and the Indoor Unit's
OPERATION Indicator Lamp and TIMER
Indicator Lamp will begin to flash simulta-
neously.
● To stop the test operation mode, press the
START/STOP button to stop the air condi-
tioner.
Y RESET button
Z Remote Control Unit Display (Fig. 7)
[ Transmit Indicator
\ Fan Speed Display
] SWING Display
^ T imer Mode Display
a Clock Display
b Temperature SET Display
c ECONOMY Display
d Operation Mode Display
e COIL DRY Display
f SLEEP Display
/
)
En-4

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Aobr09lgcAsba12lgcAobr12lgc

Table of Contents