Bush Heritage 2 User Manual page 10

Note: If a password (WEP/WPA) isn't required by your network, radio will connect
to the network automatically.
a. Turn SELECT/SNOOZE knob to cycle through the alphanumeric character list,
press SELECT/SNOOZE knob to select an appointed character.
Note: WEP/WPA pass codes are case-sensitive.
b. If a wrong operation is being conducted, select
character.
Note:
radio will automatically save the WEP/WPA you've input, so no bother to
re-enter these codes.
c. After selecting the final character of your password, turn SELECT/SNOOZE knob to
connected to wireless network.
2) If you wish to establish a connection via WPS, press SELECT/SNOOZE knob after you
have selected desired network. The radio then offers the option to initiate WPS.
Turn SELECT/SNOOZE knob to select through PUSH Button, PIN and Enter Passkey,
press SELECT/SNOOZE knob to confirm.
Push Button
PIN
Skip WPS
5. Setup wizard completed, press SELECT/SNOOZE knob again to exit.
10
= Backspace;
, and then press SELECT/SNOOZE knob to confirm. The radio is
You must start the WPS scan on the remote station (e.g. router).
Consult the manual for your router or Access Points (AP) to learn
how to do this.
After you have done this, press SELECT/SNOOZE knob on the
radio and then both devices will establish a connection.
The radio creates an 8-digit number, which you then have to enter
into the remote station.
After entering the PIN, press the SELECT/SNOOZE knob to
establish the connection between both devices.
In addition to a WPS connection, you can also establish a
connection using a Pre-Shared-Key. The required key is often on
the rear of the router, or you may have defined it yourself.
This method is used automatically for networks without WPS. You
can call up the Pre-Shared-Key function on networks with WPS by
selecting menu item "Skip WPS".
An input field should now appear. You can enter the required key
(PSK) by turning and pressing SELECT/SNOOZE knob, and then
select "OK" and press SELECT/SNOOZE knob complete the entry.
The radio should now establish the connection to the network.
to delete designated
means return to previous track;