Page 1
Owner and installer guide Mains pressure indoor stainless steel cylinders Models: HJ Cooper mains pressure premium duplex stainless steel cylinders (‘MS’ electric prewired series) Hello installer Please leave this guide with the home owner as it contains important safety and warranty...
Page 2
For more information about buying, using, and servicing of Rinnai appliances call: 0800 RINNAI (0800 746 624) Rinnai New Zealand Limited 105 Pavilion Drive, Mangere, Auckland...
Every six months operate the During servicing of your the best advice on your Rinnai easing gear to remove lime cylinder the TPR valve product. Regular maintenance IMPORTANT...
Troubleshooting Do not attempt to carry out any work other than that mentioned in this troubleshooting section. If you have any other faults or problems, please contact your installer, or contact Rinnai. Problem Possible solution Lack of hot Is there electricity supply to the cylinder? water or no hot Check that the isolating switch marked ‘hot water’...
Specification summary Suitability Weights (empty/full) • Indoor installations • 135 L: 26.5/161.5 kg • Main and low pressure systems • 180 L: 31.5/211.5 kg • Left or right hand plumbing connections • 250 L: 41/291 kg • Connection to open loop solar, or hot water • 300 L: 46.5/346.5 kg heat pump systems.
Dimensions Diameter ½ “ female TPR (all sizes) Optional upper element (250 and 300 L only) ½ “ female eco inlet (180, 250, 300 L only) ¾ female“ side cold inlet (all sizes) Hot water outlet ¾ “ female Side cold inlet Side cold inlet Element Tank size A (mm)
Drip tray/catch pan - MUST be fitted The Rinnai warranty does not cover any consequential loss from leaks to the cylinder, so it’s important a suitably drained drip tray/catch pan is fitted. 10 | Mains pressure indoor stainless steel cylinders: Owner and installer guide: 20132-D 04-15...
Pipe work It is the installer’s responsibility to adequately size the distribution pipe work in a property to ensure sufficient performance from all outlet fittings. Water pipe sizing should be performed in accordance with AS/NZS 3500.4 and/or G12 AS1. Pipe sizing and valve selection must be performed to allow for the water supply pressure.
Most metropolitan water supplies fall within these limits. If you are unsure about water quality, please contact Rinnai and we will provide you with the details of an authorised agency able to test your water for compliance to Rinnai standards. If sludge or foreign matter is present in the water supply, a suitable filter should be incorporated in the water supply.
Electrical supply and connections The electrical connection must be carried out by a qualified person in accordance with NZ Electrical Regulations. The water heater must have the heating element connected to an independent, fused, AC 230 V 50 Hz power supply with an isolating switch installed at the switch board.
Valves and fittings Valves with pressure ratings other than those listed in this manual must not be used. Fittings supplied with the cylinder TPR valve, brass plugs, to plug unused connections, a key spanner, and the owner and installer guide are packaged in a plastic bag inside the element cover. Commissioning Commissioning and draining activities must be carried out by an authorised person.
20 Year Limited Warranty Rinnai warranty summary table This warranty applies to HJ Cooper by Rinnai Mains Pressure Stainless Steel cylinders only. All terms of the warranty, subject to the conditions below, are effective from the date of installation. Proof of installation date will be required. Where the date of installation is not known or cannot be proven the warranty will commence one month after the date of manufacture—refer to the data...
Page 16
8. Rinnai reserve the right to have the installed product returned to the factory for inspection. 9. Where the cylinder is installed outside the metropolitan area or further than 40 km from a Rinnai authorised service centre, travel costs shall be the owner’s responsibility.
Page 17
6. Where it is found that there is no fault with the cylinder and the issue is related to the installation or is due to power failure. 7. Subject to any statutory provisions to the contrary, Rinnai does not accept: a. liability for consequential damage or any incidental expenses resulting from any breach of the warranty, b.
Pro rata warranty explanation and scenarios Years 11-20 of the HJ Cooper by Rinnai Mains Pressure Stainless Steel cylinders are covered by a pro rata warranty where the replacement cost is reduced according to the age of the cylinder. This is calculated using the following formula.
Proof of purchase RECORD YOUR DETAILS ATTACH YOUR PROOF OF OF PURCHASE BELOW: PURCHASE HERE: Retailer: Retailer address: Date of purchase: Product details: Please keep these details in a safe place for future reference. Installer details Company name: Installer name: Address: Phone: Mobile:...