Overview; General Description; Important Information Before Supplying Power To Unit; Hot Water Output - STIEBEL ELTRON MINI 2-1 Operation And Installation

Tankless electric water heater with electromechanical flow switch
Table of Contents

Advertisement

Available languages

Available languages

OPERATION

OvERvIEW

THIS MANUAL MUST BE READ CAREFULLY BEFORE ATTEMPTING TO INSTALL THE MINI
THE SAFETY RULES OR THE INSTRUCTIONS OUTLINED IN THIS MANUAL, THE UNIT MAY NOT OPERATE PROPERLY AND IT COULD
CAUSE PROPERTY DAMAGE, SERIOUS BODILY INJURY AND/OR DEATH.
STIEBEL ELTRON, INC. WILL NOT BE LIABLE FOR ANY DAMAGES BECAUSE OF FAILURE TO COMPLY WITH THE INSTALLATION AND
OPERATING INSTRUCTIONS OUTLINED IN THIS MANUAL OR BECAUSE OF IMPROPER USE. IMPROPER USE INCLUDES THE USE OF THIS
APPLIANCE TO HEAT ANY LIQUID OTHER THAN WATER. FAILURE TO COMPLY WITH THE INSTALLATION AND OPERATING INSTRUCTIONS
OR IMPROPER USE VOIDS WARRANTY. NEVER REMOVE THE UNIT'S COVER UNLESS THE ELECTRICITY IS TURNED OFF.
IF YOU HAVE ANY QUESTIONS REGARDING THE INSTALLATION OR OPERATION OF THIS WATER HEATER, OR IF YOU NEED ANY ADDITIONAL
INSTALLATION MANUALS, PLEASE CALL OUR TECHNICAL SERVICE LINE ON 800-582-8423 (USA AND CANADA ONLY). IF YOU ARE CALLING
FROM OUTSIDE THE U.S. OR CANADA, PLEASE CALL USA 413-247-3380 AND WE WILL REFER YOU TO A QUALIFIED STIEBEL ELTRON
SERVICE REPRESENTATIVE IN YOUR AREA.
6.
Overview
6.1

General Description

The Mini
tankless water heater differs from conventional storage
type water heaters in several ways. It does not store hot water.
Instead, water is heated instantaneously as it flows through the
unit. The powerful heating elements are activated by a flow
switch as water is drawn from a hot water faucet connected to
the Mini
. Due to the absence of stand-by losses, the Mini
greater energy efficiency than storage type water heaters. The
unit will continuously supply hot water as long as the faucet is
open.
The temperature of the hot water delivered by the Mini
on the wattage of the heating element, the temperature of the
incoming cold water, and the water flow rate through the unit.
In order for the Mini
to operate properly, it must be carefully
matched to the application.
In case you have questions regarding the way you plan to use the
Mini
, please call our technical service line at 800-582-8423 (USA
and Canada). For service outside the U.S. and Canada, please call
us at USA 413-247-3380. You can also e-mail us at info@stiebel-
eltron-usa.com or fax us at 413-247-3369.
The Mini
can be used for hand washing type applications in the
U.S. and Canada:
– Restroom sinks in commercial/industrial facilities and homes
– Kitchen areas in commercial /industrial facilities and homes
– Cabins
– Special uses in photo developing shops, laboratories etc.
The Mini
can also be used for whole apartments and
homes in warm climate zones such as the Caribbean region,
Central America and Mexico due to the higher ambient water
temperatures.
6
| MINI
SERIES TANKLESS ELECTRIC WATER HEATERS
6.2
Important information before supplying power
to unit
Air in the cold water pipe will destroy the bare-wire
heating system of the Mini
Mini
has been interrupted, for example due to the risk of frost
or work on the water pipe, the following steps must be carried
out before the unit is used again.
offers
» 1. Turn off circuit breaker.
» 2. Open a hot water tap downstream of the unit for as long as
is necessary for the unit and the cold water pipe to be free of
air.
» 3. Turn on circuit breaker.
depends
All information in these Instructions for Use and Installation
must be followed carefully. They provide important information
with regard to safety, operation, installation, and maintenance
of the device.
6.3

Hot water output

Model
Mini
2-1
Mini
2.5-1
Mini
3-1
Mini
3.5-1
Mini
4-2
Mini
6-2
Mini
2-1 models are internally restricted to 0.32 gpm (1.2 l/min).
Mini
2-1, 2.5-1, 3-1 ship with a 0.5 gpm (1.9 l/min) pressure
compensating flow reducer/aerator that must be installed. Mini
3.5-1, 4-2 ship with a 0.66 gpm (2.5 l/min) pressure compensating
flow reducer/aerator that must be installed.
WATER HEATER. IF YOU DO NOT FOLLOW
. If the water supply to the
Wattage at
Typical hot water
max rated
output
voltage
1.8 kW
0.32 gpm / 1.2 l/min
2.4 kW
0.50 gpm / 1.9 l/min
3.0 kW
0.50 gpm / 1.9 l/min
3.5 kW
0.66 gpm / 2.5 l/min
3.5 kW
0.66 gpm / 2.5 l/min
5.7 kW
1.00 gpm / 3.8 l/min
WWW.STIEBEL-ELTRON-USA.COM

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mini 4-2Mini 6-2Mini 2.5-1Mini 3-1Mini 3.5-1

Table of Contents