Problem Solving Guide - Miele DG 2351 Operating And Installation Instructions

Miele steam oven operating and installation instructions
Table of Contents

Advertisement

Installation work and repairs to
electrical components of this
appliance must only be carried out
by a suitably qualified and
competent person in accordance
with local and national safety
regulations. Repairs and other work
by unqualified persons could be
dangerous. The manufacturer
cannot be held liable for
unauthorised work.
What to do if, ...
... the fan can still be heard after the
appliance has been switched off.
The appliance is fitted with a fan which
removes steam from the oven.
The fan will continue to run for a while
after the appliance has been switched
off.
... you cannot switch the appliance
on.
Check whether the mains fuse has
blown.
If this is not the case, then disconnect
the appliance from the electricity
supply for approx. 1 minute. To do this:
– switch off at the wall socket and
withdraw the plug, or
– switch off at the isolator, or
– withdraw the mains fuse.
Reconnect to the mains supply and
switch the appliance on. If it still will not
start, contact a qualified electrician or
the Miele Service Department.

Problem solving guide

... when the appliance is switched on
only the symbol $ appears.
The safety lock is activated. Deactivate
the lock as described in "System lock".
... the appliance does not heat up.
Check whether you set the demo-mode
setting by mistake (see "Standard
settings").
... the water container has become
harder to put into the appliance and
take out again.
Lightly lubricate the coupling seal on
the water container with silicone
grease, as described in "Seals".
... the heat-up phase lasts an
unusually long time.
Check the bottom of the water
container.
If a thick layer of limescale has built-up,
check the water hardness level that has
been set. Set the correct water
hardness level for your water supply
(see "Setting the water hardness level")
and descale the appliance as
described in "Descaling".
If the water hardness level was in fact
set correctly or the problem occurs
again, contact the Service Department.
53

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dg 2551Dg 2561Dg 2651Dg2661

Table of Contents