Table of Contents
Advertisement
Precautions
Do not operate this product beyond its specified tem-
perature, humidity, or power source ratings.
Use this product at temperatures between 5 °C to 45 °C
{41 °F to 113 °F} and where the humidity is between 5 % to
90 %.
The input power source for the NTSC model is 120 V AC
60 Hz, and for the PAL model is 220 V to 240 V AC 50 Hz.*
Performance and lifetime of hard disk drives are easily affected
by heat (used at high temperature).
It is recommended to use this product at temperatures
between 20 °C to 30 °C {68 °F to 86 °F}.
* The provided power cords are dedicated to the use with this
product.
POWER switch
The POWER switch is located at the rear of this product. Even
though the POWER switch is set to "OFF", the power supply
will not be cut. To cut the power supply, remove the power
plug of this product from the AC outlet. When using the power
supply control unit, turn off the power of the power supply
control unit.
Hard disk drive (HDD)
• Hard disk drives are vulnerable to vibration. Handle them
with care.
It is possible to damage them if they are moved while their
motors are still running.
• Do not move them just after turning the power off (for
around 30 seconds).
• The lifetime of hard disk drives is limited by use. Write
errors may occur frequently after around 20 000 hours of
operation, and the head and motor deterioration may
occur after 30 000 hours of operation. They will reach the
end of their lifetime after 30 000 hours of operation if they
have been used at the recommended ambient tempera-
ture (approx. 25 °C {77 °F}).
• It is recommended to replace them after around 18 000
hours of operation to prevent data loss from disk failures.
• When hard disk drive trouble occurs, replace it immediate-
ly.
Contact your dealer about servicing.
Prevent condensation from forming on the surface of the
hard disk drive.
If this happens, do not turn on the power of this product.
Instead leave it switched off for around 2 hours.
Wait until the dew evaporates in any of the following cases:
• This product is placed in an extremely humid place.
• This product is placed in a room where a heater has just
been turned on.
• This product is moved from an air-conditioned room to a
humid or high-temperature room.
When this product has not been used for a certain peri-
od, turn on the power (approximately once a week), and
perform recording/playback to prevent interferences
with functions.
Cleaning
• Turn the power off when cleaning this product. Otherwise it
may cause injuries.
• Do not use strong or abrasive detergents when cleaning
the body. Use a dry cloth to clean this product when it is
dirty.
• When the dirt is hard to remove, use a mild detergent and
wipe gently.
• When using a chemical cloth for cleaning, read the caution
provided with the chemical cloth product.
Product disposal/transfer
Data saved on the hard disk drive may lead to personal infor-
mation leakage. When it is necessary to dispose of or give this
product to someone, even when for repair, make sure that
there is no data on the hard disk drives.
Indication label
Refer to the indication label placed on the surface of this prod-
uct as to the indications of equipment classification and power
source, etc.
Handle this product with care.
Do not strike or shake, as this may damage this product.
Do not strike or give a strong shock to this product.
It may cause damage or allow water to enter this product.
7
Hide quick links:
Advertisement
Table of Contents
