Remove The Hdd Units - Panasonic WJ-HDE400 Installation Manual

6
Press the arrow button (up or down) repeatedly until
the "Link EXT" indication is displayed.
7
Move the underscore mark below "YES" using the
arrow button (left or right), and then press the [SET]
button.
8
Select the HDD slot number to which the HDD unit is
to be inserted using the arrow button (up or down),
and then press the [SET] button.
9
Move the underscore mark below "YES" using the
arrow button (left or right), and then press the [SET]
button.
All the installed HDD units will be recognized as the HDD
units for recording use.
When the [SET] button is pressed, the display on the LCD
will return to the time and date menu.
10
Close the front cover and lock it by pushing and
turning the key to the left.
Keep the key in a safe place.
(1)
11
Check the disk information.
The following can be checked on the "Disk information"
page on the setup menu of the recorder. Refer to the man-
uals provided with the recorder for further information.
26
* When using a recorder (not a network disk recorder), refer to
the manuals provided with the recorder for how to operate.
● Remove the HDD units
It is possible to remove the HDD unit without stopping the
operation.
Refer also to the manuals provided with the recorder.
1
The following operations are to be performed on the net-
work disk recorder.*
2
3
(2)
4
5
• Total capacity of the hard disk drive
• Available (remaining) capacity of the hard disk drive
• Hour meter
• Operational mode of the hard disk drive
• Time and date range of the images recorded on the
hard disk drive.
After inserting the provided key into the key hole on
the front cover, push and turn it to the right to open
the front cover.
(2)
Hold down the [USE] button for 2 seconds or more.
The buzzer will sound.
Press the arrow button (up or down) repeatedly until
the "HDD Operation" indication is displayed.
Press the [SET] button.
Press the arrow button (up or down) repeatedly until
the "Remove HDD" indication is displayed.
(1)