Cable Clamp - Panasonic WJ-HDE400 Installation Manual

● Cable clamp
Fix the connection cable using the provided cable clamp as
follows.
1
Attach the cable clamp fixing belt to the fixing hole
on the rear, and pass the cable through the holder
part of the cable clamp.
Pull the cable clamp fixing belt to confirm that the fixing
belt is attached firmly.

Cable clamp

fixing belt
Holder part
2
Close the clamp.
3
Slide the cable clamp toward the connector end of
the connection cable, and then hold the connector
end of the connection cable.
Make sure that the connection cable is connected firmly.
Note:
• Overhead view
(1)
(2)
(1) Hold the connector end of the connection cable by
tightening the clamp. It may be difficult to hold the
connector end when the cable clamp is not slid all the
way to the connector end side.
(2) To slide the cable clamp in the direction of arrow indi-
cation (2), slide it while keeping the knob pulled down.
(1) Knob
Clamp
Connector end of the
connection cable
13