Troubleshooting; If The Following Things Happen; In Case Of Power Failure - Casio SE-S10 Service Manual

55

TroubleshooTing

5555

if the following things happen

Symptom/Problem
1 e05 appears on the display.
2 e08 appears on the display.
3 e50 appears on the display.
4 e90 appears on the display.
5 e85 appears on the display.
6 No date on receipt.
Paper is not advancing
enough.
7 Drawer opens up after ringing
up only one time.
8 Not clearing totals at end of
day after taking report.
9 Programming is lost whenever
register is unplugged or there
is a power outage.
10 Register is inoperative.
Can't get money out of
drawer.
5555

in case of power failure

If the power supply to the cash register is cut by a power failure or any other reason, simply wait for
power to be restored.The details of any ongoing transaction as well as all sales data in memory are
protected by the memory backup batteries.
· Power failure during a registration
The subtotal for items registered up to the power failure is retained in memory.You will be able to
continue with the registration when power is restored.
· Power failure during printing a read/reset report
The data already printed before fhe power failure is retained in memory.You will be able to issue a
report when power is restorted.
· Power failure during printing of a receipt and the journal Printing will resume after power is restored.A
line that was being printed when the power failure occurred is printed in full.
· Other
The power failure symbol is printed and any item that was being printed when the power failure
occurred is reprinted in full.
Most common causes
Changing modes without
completing transaction.
Sign on operation is not
performed.
Printer head (platen arm) is
opened or no papaer roll.
Totals remain in the memory.
Electronic journal memory
becomes/ is full.
Printer is programmed as a
journal.
Department is programmed
as a single item dept.
Using X mode to take out
reports.
Bad or no batteries.
No power.
— 29 —
Solutions
Return mode switch to where it
stops buzzing and press
Prior to starting registration
of any other operation, press
~ and then
1 8
%
CLK#
Close the platen arm fi rmly or
enter paper roll.
Issue the general control reset
report, periodic reset report
and PLU reset report.
Issue electronic journal reset
report.
Program printer to print receipts.
Program the dept. as a normal
dept.
Use Z mode to take out
reports.
Put in new batteries.
Pull lever underneath register
at rear.
.
CA AMT
= TEND
.