Troubleshooting - Casio 140CR-272 Service Manual

6. TROUBLESHOOTING

140CR
Symptom/Problem
1 E01 appears on the display.
2 E08 appears on the display.
3 E94 appears on the display.
4 No date on receipt.
Paper is not advancing enough.
5 Drawer opens up after ringing up
only one time.
6 Not clearing totals at end of day
after taking report.
7 Programming is lost whenever
register is unplugged or there is
a power outage.
8 Register is inoperative.
Can't get money out of drawer.
9 E90 appears on the display.
PCR-272
Symptom/Problem
1 E01 appears on the display.
2 E08 appears on the display.
3 E94 appears on the display.
4 No date on receipt.
Paper is not advancing enough.
5 Drawer opens up after ringing up
only one time.
6 Not clearing totals at end of day
after taking report.
7 Programming is lost whenever
register is unplugged or there is
a power outage.
8 Register is inoperative.
Can't get money out of drawer.
Most common causes
Changing modes without
completing transaction.
Sign on operation is not
performed.
Printer paper is jammed.
Printer is programmed as a
journal.
Department is programmed as a
single item dept.
Using X mode to take out reports. Use Z mode to take out reports.
Bad or no batteries.
No power.
Totals remain in the memory.
Most common causes
Changing modes without
completing transaction.
Sign on operation is not
performed.
Printer paper is jammed.
Printer is programmed as a
journal.
Department is programmed as a
single item dept.
Using X mode to take out reports. Use Z mode to take out reports.
Bad or no batteries.
No power.
— 18 —
Solutions
Return mode switch to where it
stops buzzing and press
Prior to starting registration of
any other operation, press
and then .
%
CLK#
Remove jammed paper. Turn
Mode switch to OFF then turn to
ON, or Turn power OFF and then
turn power ON.
Program printer to print receipts.
Program the dept. as a normal
dept.
Put in new batteries.
Pull lever underneath register at
rear.
Issue the general control reset
report, periodic reset report and
PLU reset report.
Solutions
Return mode switch to where it
stops buzzing and press
Prior to starting registration of
any other operation, press
and then .
%
CLK#
Remove jammed paper. Turn
Mode switch to OFF then turn to
ON, or Turn power OFF and then
turn power ON.
Program printer to print receipts.
Program the dept. as a normal
dept.
Put in new batteries and program
again.
Pull lever underneath register at
rear.
.
CA AMT
= TEND
~
.
CA AMT
= TEND
~