Sanyo PLC-XU106 Service Manual page 16

Mechanical Disassembly
b Power, Ballast, Lamp Cover Sw Board, Thermal Sw(SW902) removal
1. Remove two Isolation sheets.
. Remove 3 screws A(T3x6) and  screws B(T3x8) to remove the Power
board holder.
3. Remove screw C(T3x6) to remove the Power board.
4. Remove  screws D(T3x6) to remove the Ballast board.
5. Remove screw E(T3x6) to remove the Lamp cover switch board and remove
screw F(T3x6) to remove the thermal switch (SW90).
D
Power board
Ballast board
B
Power board holder
A (T3x6)x
Isolation sheets
C (T3x6)
D (T3x6)x
B (T3x8)x
Lamp cover
switch board
E (T3x6)
F (T3x6)
A
-16-
Themal switch
(SW90)
Fig.5