Front Suspension; Rear Suspension - Ossa TRi User Manual

Front suspension

The front suspension is made up of a fork that fixes the wheel
and the front brake system in place. This fork is formed by the
suspension bars that contain the shock absorber spring and the
suspension mechanism. They are connected to the upper part
where the direction pipe is located, a point of connection between
the fork and the chassis. A regulating screw and an air bleed are
located on the upper part of each suspension bar (see photo).
To regulate the extension, use the screw located on the right sus-
pension bar (Fig. A)
To regulate the compression use the screw located on the left
suspension bar (Fig. B)
Each of the suspension bars also has an air bleed to remove air
that accumulates in the inside of the fork stanchion (Fig. C)
24
OSSA TRi - User manual
B
A
C C
The rear suspension is formed by a single shock absorber spring.
The pre-charge of this spring can be adjusted by turning the too-
thed rings that dictate its direction.
A special key is needed to adjust these toothed rings.
The compression (C), extension (R) and spring pre-charge (see
Fig.)are adjustable in the rear shock absorber.

Rear suspension

C
R
Adjustable rings for the spring pre-charge
25
OSSA TRi - User manual