Table of Contents
Advertisement
Multi-function box
Temperature selector
To
select
the
unit
of
temperature,either ºC or ºF,
press button 1. Confirm the se-
lection by pressing button 2.
1
2
3
Danger temperature selector
Note:
This stage should only be imple-
mented for those vehicles that
have an optional temperature
sensor. When the motorcycle
temperature exceeds the set
value, right-hand warning light
comes on. Default value: 110ºC
(230ºF).
Enter the value by pressing
button 1 repeatedly. To move on
1
2
3
to the next digit, press button 3.
Confirm the selection by pres-
sing button 2.
20
OSSA TRi - User manual
Warning temperature selector
Note:
This stage should only be imple-
mented for those vehicles that
have an optional temperature
sensor. When the motorcycle
temperature exceeds the set va-
lue, the left-hand warning light
comes on.
Default value: 90ºC (190ºF). En-
ter the value by pressing button
1
2
1 repeatedly. To move on to the
3
next digit, press button 3. Con-
firm the selection by pressing
button 2.
Gear change turn rate selector
When the set rate is near to be-
ing reached, the left-hand war-
ning light will flash, indicating
the need to change gear.
Default value: 6000 rpm
Enter the value by pressing
button 1 repeatedly. To move on
to the next digit, press button 3.
1
3
2
Confirm the selection by pres-
sing button 2.
Dangerous turn rate selector
When the set rate is near to be-
ing reached, the right-hand war-
ning light will flash, indicating
that the engine is turning at an
excessive rate.
Default value: 10,000 rpm. En-
1
ter the value by pressing button
2
1 repeatedly. To move on to the
next digit, press button 3. Con-
firm the selection by pressing
button 2.
2
3
Setting the indicator functions to zero after each use of the vehicle
After each use of the vehicle, it's possible to set the following
functions to zero, simultaneously:
- Maximum speed
- Distance
- Chronometer
- Maximum temperature
- Maximum turn rate
Confirm that you want to set these functions to zero by simulta-
neously pressing buttons 1 and 2.
Multi-function box
Setting the whole multi-function box to zero
Press the RESET button by using a suitable object. The indicator
will boot again, excluding data that corresponds to total accumu-
lated distance and time.
CLOSE
OPEN
3
RESET
POSITIVE
BATTERY CR2030
Internal battery
The multi-function box works with a 3V internal battery, type
CR2032. When the battery tension falls beneath 2.45V, the screen
displays the LO indicator. To change the battery, open the lid on
the bottom of the indicator by unscrewing it as is indicated in the
image, using a coin. Ensure that the positive side of the battery is
facing upwards.
OSSA TRi - User manual
21
Advertisement
Table of Contents
