How To Connect Wirings And Wiring Example - Daikin FAY71LVE Installation Manual

8. HOW TO CONNECT WIRINGS AND WIRING EXAMPLE

8-1 HOW TO CONNECT WIRINGS
Methods of wiring units and connecting remote controller wiring
• Wiring between units
Unscrew and remove the service lid.
Connect the wiring between units of matching number to the power supply terminal block (4P). And connect
the ground wiring to the ground terminal.
When doing this, tie the wiring between units and the ground wiring using the included clamp (small) (5) and
then firmly secure using the included clamp (small) (5) according to the figure.
(Refer to Fig. 20)
• Remote controller wiring
Unscrew and remove the service lid.
Connect the remote controller wiring to the terminal block (5P).
When doing this, tie the remote controller wiring using the included clamp (small) (5) and then firmly secure
using the included clamp (small) (5) according to the figure. (Refer to Fig. 20)
Outdoor
Indoor
unit
unit
1 1
2 2
3 3
(Wiring between unit)
How to connect power
supply terminal block
(4P)
In case of using the power
supply terminal together with
the other connecting wirings
1 2 3
Make sure to process
the insulation at the wire
terminal part properly so that
the terminals do not get in
contact each other.
English
Power supply
terminal block (4P)
Ground terminal
Ground wiring
Wiring the units
Terminal block
for the remote
controller (5P)
< Wiring clamp method >
1 2 3
Ground wiring
Remote controller
code
Clamp small (accessory) (5)
Clamp small (accessory) (5)
(3 places)
P1 P2 F1 F2
REMOTE TRANSMISSION
Cut off any excess
CNTRL WIRING
material after tightening.
Remote controller wiring
Fig. 20
Clamp small (accessory) (5)
Clamp after tying the
wiring between the units
and the ground wiring.
Wiring between units
14