Daikin FAY71LVE Installation Manual page 11

(6) Hook the indoor unit onto the installation panel. (Refer to Fig. 9)
• Placing buffering material between the wall and the indoor unit at this time will make work easier.
Front panel
Be sure to pass all wires through
the wiring guide.
Refrigerant pipe
Wiring (locally procured)
Wiring the units, Ground wiring, Remote controller wiring
For right, bottom-right, and back-right piping
• Pass the drain hose and the refrigerant piping to the wall.
(7) Pass wiring the units, ground wiring, and remote controller wiring through the wiring guide in
through the back of the indoor unit and to the front.
(8) Connect the piping. (See "5.REFRIGERANT PIPING WORK" and Fig. 10)
Drain hose
Wiring
Seal with putty corking
material.
Fig. 10
• To avoid the influence of noise from the power supply line on the remote controller wiring, this wiring
must be kept as far as possible from wiring the units/ground wirings. As shown in the Fig.10, keep the
wiring the units and the ground wiring together. Route remote controller wiring maintaining a good dis-
tance from the wiring the units/ground wirings (that is, on the other side of the wiring the units/ground
wirings). Then, fix them securely on the refrigerant pipe.
• Seal the piping through-hole with putty corking material.
(9) Push on both bottom edges of the indoor unit using both hands and hook the tab on the back of
the indoor unit onto the installation panel (1). (Refer to Fig. 9)
• At this time remove the buffering material placed in step (6).
English
Service lid
Hook the indoor unit hook onto the installation panel (1).
Front grill
Tab
(There are 2 places.)
Secure with
vinyl tape.
Refrigerant piping
Wrap the insulating tape overlapping at least half the width with
each wrap.
Wrap the insulating tape all the way to the L-shaped bend.
Place buffering material
Wall
Installation panel
(accessory) (1)
Fig. 9
Wiring the units and
ground wiring
Refrigerant piping
A
Remote controller wiring
A arrow view
8