Vertex Standard VXA-220 Operating Manual page 42

SQL
Function: Squelch Level Setting.
Available Values: 0 ~ 8
Default Setting: 6
Select a setting for this Menu item which just silences the
receiver when no signal is present. Use the lowest setting
which will keep the receiver quiet between incoming trans-
missions.
MCLR
Function: Memory Channel Clear ("MR" memory only).
To clear a Memory channel:
Select the Menu Item MCLR.
Press the [ ENT (
lector knob to recall the memory channel to be erased.
Press the [ ENT (
nel (the Memory channel number will return to "001").
Important Notice: An "erased" channel cannot be restored,
and "CH-001" cannot be erased, as it is used for "Priority
Channel" operation.
40
M
ENU
)] key, then rotate the DIAL se-
)] key to clear the Memory chan-
"S " M
ET ODE
RESM
Function: Scan-Resume Mode Setting.
Available Values: 5S/CAR
Default Setting: 5S
"5S" (5-Second Pause) mode:
the scanner will halt for five seconds only, after which
scanning will resume (whether or not the other sta-
tion is still transmitting).
"CAR" (Carrier Drop) mode:
the scanner will remain halted for as long as there is a
carrier present on the channel; after the carrier drops
at the end of the other station's transmission, the scan-
ning will resume.
SCNL
Function: Scan Lamp On/Off (while paused).
Available Values: on/oFF
Default Setting: on
If you set this function to "on," the lamp will be illumi-
nated whenever the scanner pauses. The lamp will go off
automatically when scanning resumes.
BEEP
Function: Keypad Beeper On/Off.
Available Values: on/oFF
Default Setting: on
VXA-220 P VI O M
RO PERATING ANUAL