Husqvarna 2009 TC 250 Owner's Manual page 107

MUM2-250_310_450_510_2009_GB
REASSEMBLING THE FRONT WHEEL
Fit the L.H. spacer on the wheel hub.
Fit the wheel between the front fork legs so that the brake disc
is fitted into the caliper.
18-11-2008 11:18 Pagina 41
Fit the wheel axle (2) from the R.H. side, after greasing it and
push it to the stop on the L.H. leg; during this operation, the
wheel should be turned. Tighten the screw (3) on the fork L.H.
side but DO NOT lock it. Now, pump for a while, pushing the
handlebar downwards until you are sure that the fork legs are
perfectly aligned.
Lock: the screws (1) on the R.H. leg (10,4 Nm/ 1,05 Kgm/ 7.7
ft-lb), the screw (3) on the L.H. side (51,45 Nm/ 5,25 Kgm/
38 ft-lb), the screws (1) on the L.H. leg (10,4 Nm/ 1,05 Kgm/
7.7 ft-lb).
2
1
NOTE
After reassembly, pump the brake control lever until the pads
are against the brake disc.
1
3
41