Installation & Accessories - Haier WD9900 Service Manual

INSTALLATION & ACCESSORIES/ PARTS
Unpacking leveling and positioning
Remove the package and check that the washer's dryer is undamaged.
If you have any doubts, call on a qualified technician. Keep all packing parts (plastic
bag, foam, rubber, screws etc.) out of the reach of children since they could pose a
threat.
Important:
The inside of the washer's dryers consists of a floating unit, which is fixed with
screws at the back of the cabinet. During transportation, before starting the machine
remember to release the floating unit by removing the above screws and to prevent
water from entering the machine, remember to close the holes left open by the
screws with the plastic caps provided in the packet containing the owner 's manual.
It is important for the machine to be perfectly level (the angle of inclination on the
work surface must not be more than 2 degrees). For this reason the machine is fitted
with adjustable feet used for leveling the machine before use. In case of a floor with
carpeting, remember to check that the ventilation in the support area is not blocked.
Electrical Connection
Connect the plug to a socket provided with efficient earthing. (Warning: This
appliance must be earthed as a safety measure according to the law).
Make sure that the voltage and frequency available correspond with the values
stated on the data plate located at the back of the machine and that the electric
system is dimensioned to withstand the maximum current shown on the data plate.
If the socket connected to the machine does not correspond with the plug, replace
the plug with a suitable one and avoid using adaptors or shunts since they could
cause overheating and burning out.
Connection of tap and loading hose
Connect the inlet hose to a cold-water tap and check that it is tightly screwed to the
tap. If the water piping is new or has not been used for a long time, before making
the connection, let the water run until it is clear and free from impurities.
This step is necessary to ensure that the incoming water does not clog and possibly
damage the machine.
Checking the connections
Turn the tap to maximum to check if any leakage. If yes, reassemble it then.
Note:
1.The connecting and the inlet hose can be re-assembled many times.
2. If the pipe is new or its long been absent from use, let go the dirty, rusty
water first till it turns clean.
Connecting the Drain Hose
Connect the drain hose to a drain duct (with internal diameter of at least 1.6 inch) or
place it for drainage into a sink or a tub, ensuring that there are no kinks or bends.
The free end must be at a height of between 31.4 and 39.3 inch. It need be to fix the
end of the hose at a height of no less than 31.5in from the floor, the hose must be
fixed in the appropriate hook on the upper part of the back panel or use the supplied
support to fix the drain hose.
10