Connecting Your Labelwriter Printer; To Connect The Power - Dymo LabelWriter 450 Quick Start Manual

3. Connecting your LabelWriter Printer

Do not connect the printer to your computer until after the
NOTE
software installation is complete.

To connect the power

Plug the power cord into the power adapter. See Figure 3.
1
Plug the power adapter into the power connector on the bottom of
2
the printer. See Figure 4.
Plug the other end of the power cord into a power outlet.
3
Plug the USB cable into the USB port on the bottom of the printer.
4
Insert the power and USB cables through the cable channel and set
5
the printer down.
When the software is completely installed, connect the other end of
6
the USB cable into an available USB port on your computer.
If the printer is not in the printer list when the installation is
Mac OS
complete, refer to the ReadMe file for instructions on how to add the printer.
4
Power adapter
Power cord
Figure 3
USB
USB 24VDC
Cable
channel
Figure 4
Power