LG LDE3037SB Owner's Manual page 35

34
CARE AND CLEANING
EasyClean™ INSTRUCTION GUIDE
1. Remove oven racks and accessories from the oven.
plastic scraper.
Suggested plastic scrapers:
water and use the spray bottle to thoroughly spray
the inside surfaces of the oven.
completely saturate the soil on both the walls and in
the corners of the oven.
of water onto the bottom center of the oven cavity.
The indentation on the oven bottom should be fully
covered to submerge all soils. Add water if necessary.
NOTE
Use the "mist" setting on the spray bottle for better coverage.
be used for each oven cavity cleaned.
Do not spray water directly on the door. Doing so
will result in water dripping to the floor.
6. Close the oven door.
Press the button.
Press the button.
CAUTION
Wear rubber gloves while cleaning to prevent burns.
hot enough to cause burns. Wait until the cycle is
over before wiping the inside surface of the oven.
while cleaning the oven cavity.
Press the button to clear the display and
end the tone.
enough water should remain on the oven bottom
to completely submerge all soils. Add water if
necessary. Place a towel on the floor in front of the
oven to capture any water that may spill out during
a double oven range, it is also best to cover the holes
in the top of the lower oven door with a towel to
capture any water that may drip into the door during
hand cleaning.
9. Clean the oven cavity immediately after the
scratch scouring sponge or pad. (The scouring side
will not scratch the finish.) Some
water may spill into the bottom
vents while cleaning, but it will be
captured in a pan under the oven
cavity and will not hurt the burner.
NOTE
DO NOT use any steel scouring pads, abrasive pads
or cleaners as these materials can permanently
damage the oven surface.
10. Once the oven cavity is cleaned, wipe any excess
water with a clean dry towel. Replace racks and any
other accessories.
11. If some light soils remain, repeat the above steps,
making sure to thoroughly soak the soiled areas.
oven cavity is empty of oven racks and other
accessories, and that the oven cavity surface is dry
before running the Self Clean cycle. Consult the Self
Clean section of your owner's manual for further
details.
NOTE
button to end the cycle. Wait for the range to
cool to room temperature and then spray or pour
cycle.
cycle finishes. This is normal. Do not clean the
gasket.
after cleaning, use a cloth or sponge soaked in
vinegar to remove them.