Tiffin Motorhomes Allegro Bus 2016 Owner's Manual page 103

DRIVING
that the standard hydraulic leveling system is not selected, then press AUTO.
If the level controller will not go into AUTO mode, it is most likely because the vehicle's parking brake
has not been applied, the vehicle is in gear, or the ignition is off.
NOTE: Due to the sensitivity of the leveling sensors, any noticeable movements within the vehicle can
cause difficulty while leveling is in process. Therefore, if you are inside the vehicle while it is leveling,
please sit quietly or walk lightly.
When the AUTO button is pressed the AUTO indicator flashes until the cycle is complete. Then the
indicator remains on. The system first detects the lowest corner of the vehicle then lowers the remain-
ing corners to it. If the system determines that it is unable to lower the vehicle to level, any corners that
are low will then be raised to the level of the highest corner. If the system is unable to achieve level, the
SLOPE indicator will be illuminated.
Once leveling is complete (after 20 seconds), the system goes into "low power" mode indicated by the
occasional flashing of the AUTO and POWER indicators. The system will awaken periodically to re-
check level (every 2 hours by default). If this is not desired, simply turn the system off when leveling
has completed.
For more information on the air leveling system please refer to the specific manufacturer's literature
located in the Owner's Information Package.
MOBILEYE COLLISION AVOIDANCE SYSTEM
The Allegro Bus may be equipped with an optional Mobileye collision
avoidance system that aids drivers in avoiding accidents.
1. Forward collision warning indicates when a car, truck or motorcycle
in the same lane is detected.
2. Lane departure warning indicators are active abive 34MPH and if
turn signals are not used when changing lanes.
3. Headway monitoring and warning is active above 19 MPH and
displays the number of seconds to the vehicle directly in front of you
whenever that distance/time becomes 2.5 seconds or less.
4. Pedestrian and bicycle collision warning indicators are active under 31 MPH.
5. Intelligent high beam controls automatically switch headlights from low beam to high beam on dark
roads without traffic.
6. Speed limit indication is active at any speed and notifies the driver if the vehicle exceeds the allowed
speed limit detected on speed signs.
96