Operation - ALGE-Timing Timy Manual

The printer and RS232 will always receive the lap figure which is actually shown in the dis-
play and on the displayboard.
If you connect C1 with C2 (resp. C4 with C5), the lap figure (lap quantity) will switch. After-
wards the time and the lap quantity will be indicated.
You can also indicate the times after the race to the printer and RS232.

5 Operation

Standard the program starts as follows:
Countdown time
Warning signal
Quantity of laps
Before the start the display shows the following:
0001 COUNTDOWN
0:50.000
If you require another sequence number, you can indicate this BEFORE the countdown
starts. If the countdown is started, you can't indicate another sequence number – unless you
will go to menu „CYCLESTART->NEW RUN".
Now you can start the countdown with the START button.
With the STOP button you can stop the countdown and continue with the START button.
If the countdown time reaches warning signal times (30, 25 and 10 seconds), you will hear a
400Hz-tone for 1 second.
Further this tone will appear at 5, 4, 3, 2 and 1 seconds (for 0,3 seconds).
After the countdown has finished it resounds a 800 Hz-tone for 0.15 seconds and Timy will
start the programs Lapcounter and Back-up:
0001 0:01.37
GREEN
000 LAP
↑ ↓ ↓
F0 F1 F2
Green Green Red
The arrows in the display shows like seen above if you indicate for „Quantity of laps = 0".
If this value unequal to 0, all arrows will show in different directions.
A display of a lap quantity of less than 0 is impossible. If 0 is reached, the display will remain
at value 0. The quantity of laps can also be indicated via the external channels C1 and C4.
Page 8
Timy Cyclestart
: 50s
: at 30, 25 and 10 s
: 0
Top left: sequence number
Countdown time also shwon on all addressed GAZ.
All external channels are blocked.
RED
000
Quantity of laps:
↑
F3 function keys
Red to count on the lap
Red on GAZ (A)
Green on GAZ (B)