Honeywell lynx touch User Manual page 13

ICON TEXT
Alarm 99
Police
CO Alarm
Cover
Tamper
Reporter
Failure
Low
Battery
90 RF Jam
94 Phone
Line Cut
AC Loss
Automation
Fault *
Garage
Door
(Not
applicable)
Not
applicable)
About the Display and Indicators
DEFINITION
The alarm (bell) icon when a burglary alarm is activated.
"Alarm" is also displayed in a red status bar along the top of
the screen. (If programmed for display by your installer) No
display if 24 Hour Silent Response Type has been
programmed.
Displayed alternately with Carbon Monoxide when a CO alarm
is activated.
"CO Alarm" is also displayed in a red status bar along the top
of the screen.
A check system icon along with "Cover Tamper" is displayed
when a cover tamper has been detected. "Ready To Arm –
System Trouble" is displayed in a yellow status bar along the
top of the screen.
The system has identified a problem with the telephone dialer.
"Not Ready To Arm – System Trouble" is displayed in a yellow
status bar along the top of the screen. A low battery icon along
with "Low Battery" is displayed when the system's backup
battery power is low.
Appears when the system has detected an RF jamming
condition or excessive interference.
Appears when the system has detected a loss of telephone
service.
Displayed when the system has lost AC power. "Ready To
Arm – System Trouble" is displayed in a yellow status bar
along the top of the screen.
Displayed when the system has detected a Z-Wave Device
Failure
Displayed when the Garage Door has been opened. Ready To
Arm – Fault" is displayed in a yellow status bar along the top
of the screen. (* Applicable Zone Number)
Displayed in the upper left corner of the status bar. Indicates
that the system is connected to a WiFi source.
Displayed in the upper left corner of the status bar. Indicates
that the system is NOT connected to a WiFi source.
– 13 –
SYSTEM OVERVIEW SYSTEM OVERVIEW
SYSTEM OVERVIEW SYSTEM OVERVIEW