Onboard Device Configuration - Asus P5G-TVM Manual

2.4.5 Onboard Device Configuration
Advanced
OnChip IDE Device
Onboard AC97 Audio
Onboard LAN
Onboard LAN Boot ROM
Serial Port1 Address
Serial Port2 Address
Parallel Port Address
Parallel Port Mode
X EPP Mode Select
ECP Mode Use DMA
F1:Help
ESC: Exit
OnChip IDE Device
The sub-menus contains IDE function-related items. Select an item then
press <Enter> to edit.
Advanced
*** On-Chip Serial ATA Setting ***
On-Chip Serial ATA
X PATA IDE Mode
SATA Port
F1:Help
ESC: Exit
On-Chip Serial ATA [Auto]
Setting to [Disabled] disables the onchip Serial ATA controller. [Auto]
lets the BIOS auto-configure. [Combined Mode] enables PATA and
SATA, with a maximum of two IDE drives in each channel. [Enhanced
Mode] enables both PATA and SATA, supporting a maximum of six
IDE drives. [SATA Only] enables SATA to operate in legacy mode.
Configuration options: [Disabled] [Auto] [Combined Mode]
[Enhanced Mode] [SATA only]
2-14
Phoenix-Award BIOS CMOS Setup Utility
Onboard Device Configuration
↑↓ : Select Item
→←: Select Menu
Phoenix-Award BIOS CMOS Setup Utility
OnChip IDE Device
↑↓ : Select Item
→←: Select Menu
[Enabled]
[Enabled]
[Disabled]
[3F8/IRQ4]
[2F8/IRQ3]
[378/IRQ7]
[ECP]
EPP1.7
[3]
-/+: Change Value
Enter: Select Sub-menu
[Auto]
Primary
P1, P3 is Secondary
-/+: Change Value
Enter: Select Sub-menu
Select Menu
Item Specific Help
Press[Enter] to set
F5: Setup Defaults
F10: Save and Exit
Select Menu
Item Specific Help
Press[Enter] to set
F5: Setup Defaults
F10: Save and Exit
Chapter 2: BIOS setup