1.7.2
Internal connectors
1.
Floppy disk drive connector (34-1 pin FLOPPY1)
This connector is for the provided floppy disk drive (FDD) signal cable.
Insert one end of the cable to this connector, then connect the other
end to the signal connector at the back of the floppy disk drive.
Pin 5 on the connector is removed to prevent incorrect cable connection
when using a FDD cable with a covered Pin 5.
P5G-TVM Floppy disk drive connector
2.
Power LED connector (3-pin PLED1)
This 3-pin connector is for the system power LED. Connect the 3-pin
power LED cable from the system chassis to this connector. The LED
lights up when you turn on the system power, and blinks when the
system is in sleep mode.
P5G-TVM PLED setting
1-24
®
P5G-TVM
®
P5G-TVM
FLOPPY1
NOTE: Orient the red markings on
the floppy ribbon cable to PIN 1.
PIN 1
PLED1
1
Chapter 1: Product introduction