Taurus Bravissimo 35 Non Stop Manual page 17

ning the temperature regulator of the iron in a clockwise
direction. (Fig 2)
- Move the iron in a top to bottom direction while pres-
sing the steam control ( I ). Important: for cotton and
linen, it is recommended to put the iron base in contact
with the material. For other more delicate fibres, it's
recommended to keep the iron base at some centimetres
of distance.
Once you have finished using the appliance:
- Select the minimum position (MIN) using the thermos-
tat control.
- Turn the appliance off, using the on/off switch.
- Unplug the appliance to the mains.
- Remove the water from the water tank.
- Clean the appliance
Cleaning
Disconnect the appliance from the mains and let it cool
before undertaking any cleaning task.
- Clean the equipment with a damp cloth with a few
drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or base
pH such as bleach, or abrasive products, for cleaning the
appliance.
- Do not submerge the appliance in water or any other
liquid, or place it under a running tap.
How to deal with lime scale incrustations:
- For the appliance to work correctly it should be kept
free of lime scale or magnesium incrustations caused by
the use of hard water.
- To prevent this kind of problem, we recommend the use
of distilled water.
ANOMALIES
Water comes out of the holes on the
bottom of the iron when the steam
button is pressed (H).
Scale and impurities come out of the
soleplate
Steam comes out of the cleaning
stopper (K) of the detachable water
heater.
Steam does not come out when the
vapour button (H) is pressed.
Manual Bravissimo 35NS.indb 17
- However, if it is not possible to use the kind of water
recommended above, you should periodically remove the
lime scale from the appliance:
- Every 6 weeks if the water is "very hard".
- Every 12 weeks if the water is "hard".
- A specific anti-lime scale product should be used on
this kind of product.
- Homemade solutions are not recommended in the de-
scaling of this appliance, such as the use of vinegar.
Cleaning the detachable water heater
- Check that the appliance has cooled down (wait at least
3 hours after disconnecting the appliance)
-Empty the water tank (E) first and later the detachable
water heater
- To empty the detachable water heater open the stopper
lid of the boiler (k) and unscrew the deposit lid in an
anti-clockwise direction. (Fig. 3)
- Empty the water boiler and close it by screwing on the
stopper and turning it in a clockwise direction.
- Fill the water tank (E) with approximately 500ml of
water and add the selected anti-lime scale product.
- Connect the appliance (with the iron selected at maxi-
mum steam) and wait 20 minutes in order for the anti
lime-scale liquid begin to take effect.
Anomalies and repair
- Take the appliance to an authorised technical support
service if problems arise. Do not try to dismantle or repair
without assistance, as this may be dangerous.
- If the connection to the mains has been damaged, it
must be replaced and you should proceed as you would
in the case of damage.
- If any anomaly is detected, check the following table:
CAUSES
Iron temperature regulator (J)
positioned at minimum.
Detachable water heater too full.
Detachable water heater in slanting
position.
Excessive accumulation of lime
scale in the detachable water
heater.
Cleaning stopper incorrectly
screwed in.
Detachable water heater empty.
Switches (A) and (B) are turned off.
SOLUTIONS
Turn the thermostat control until
situated in the steam zone.
Remove water.
Place the appliance on a horizontal
base.
Clean the appliance. See "cleaning"
section.
Let the detachable water heater down
and completely screw in the stopper
K until.
Fill the tank with water. See "Filling
with water" section.
Turn the switches so that they are
connected.
27/07/12 12:55