Removing The Cylinder Head From The Cylinder Block - Westerbeke 26 G Technical Manual

REMOVING THE CYliNDER HEAD FROM THE CYLINDER BLOCK
To avoid the possibility of distorting the cylinder head, loosen each of the cylinder head bolts, a little at a
time, in the sequence shown below. Repeat this sequence several times until the bolts are unfastened.
Remove the cylinder head and cylinder head's gasket.
NOTE: Discard the cylinder head gasket when it is removed. When reassembling the cylinder
head to the cylinder block, install a new cylinder head gasket.
Westerbeke Engines
W 266 HEAD BOLT
LOOSENING SEQUENCE
52