Table of Contents
Advertisement
2.3.3
2.3.3
2.3.3
Installing a DIMM
Installing a DIMM
Installing a DIMM
2.3.3
2.3.3
Installing a DIMM
Installing a DIMM
Make sure to unplug the power supply before adding or removing DIMMs
or other system components. Failure to do so may cause severe damage
to both the motherboard and the components.
To install a DIMM:
1.
Unlock a DIMM socket by
pressing the retaining clips
outward.
2.
Align a DIMM on the socket
such that the notch on the
DIMM matches the break on
the socket.
3.
Firmly insert the DIMM into
the socket until the retaining
clips snap back in place and
the DIMM is properly seated.
•
•
2.3.4
2.3.4
2.3.4
Removing a DIMM
Removing a DIMM
Removing a DIMM
2.3.4
2.3.4
Removing a DIMM
Removing a DIMM
To remove a DIMM:
1.
Simultaneously press the
retaining clips outward to unlock
the DIMM.
Support the DIMM lightly with
your fingers when pressing the
retaining clips. The DIMM
might get damaged when it
flips out with extra force.
2.
Remove the DIMM from the socket.
2 - 8
2 - 8
2 - 8
2 - 8
2 - 8
A DDR2 DIMM is keyed with a notch so that it fits in only one
direction. Do not force a DIMM into a socket to avoid damaging the
DIMM.
The DDR2 DIMM sockets do not support DDR DIMMs. DO NOT install
DDR DIMMs to the DDR2 DIMM sockets.
3
1
U n l o c k e d r e t a i n i n g c l i p
U n l o c k e d r e t a i n i n g c l i p
U n l o c k e d r e t a i n i n g c l i p
U n l o c k e d r e t a i n i n g c l i p
U n l o c k e d r e t a i n i n g c l i p
D D R 2 D I M M n o t c h
D D R 2 D I M M n o t c h
D D R 2 D I M M n o t c h
D D R 2 D I M M n o t c h
D D R 2 D I M M n o t c h
1
C h a p t e r 2 : H a r d w a r e s e t u p
C h a p t e r 2 : H a r d w a r e s e t u p
C h a p t e r 2 : H a r d w a r e s e t u p
C h a p t e r 2 : H a r d w a r e s e t u p
C h a p t e r 2 : H a r d w a r e s e t u p
2
D D R 2 D I M M n o t c h
D D R 2 D I M M n o t c h
D D R 2 D I M M n o t c h
D D R 2 D I M M n o t c h
D D R 2 D I M M n o t c h
2
1
Advertisement
Table of Contents
