Configuring Pre-Recording; Configuring Motion Detection Events - Lorex LNR100 Instruction Manual

14 Using the Main Menu
4. Configure up to 6 separate schedule periods.
• Configure the start and end time for the time period on the left.
• Check the types of recording that will apply to the time period on the right: Continu-
ous, MD (Motion Detection), Alarm, or MD&Alarm.
NOTE
The system does not support alarm recording.
• A visual representation of the current schedule is shown below.
5. (Optional) Click Copy to copy the selected schedule to other channels. Select the
channels you would like to copy to and click OK.
6. Click OK to save changes.

14.1.6 Configuring Pre-Recording

Pre-recording determines the amount of time the system will record before events.
To configure pre-recording:
1. In the Schedule menu under Channel, select the camera you would like to configure
or select All.
2. Under PreRecord, select the duration for pre-recording.
3. Click OK to save settings.

14.1.7 Configuring Motion Detection Events

Motion Detection events allow the system to mark footage that has motion. This allows
you to quickly locate relevant footage through Search. You can also configure system re-
sponses to motion detection events, such as activating the system buzzer or sending an
email alert.
To configure Motion Detection events:
1. From the Main Menu, click
2. Under Channel, select the channel you would like to configure.
3. Check Enable to enable motion detection on the selected channel.
#; r. 2.0/23308/23308; en-US
and then click Motion.
49