Lorex LNR100 Instruction Manual page 36

9 Setting The Time
To sync your system with an Internet time server:
1. In the General menu, check NTP to sync your system with an Internet time server.
2. Click Set to configure NTP settings.
• Server IP: The address of the NTP server you would like to use. It is recommended
to leave the default setting.
• Port: The port used by the NTP server. It is recommended to leave the default
setting.
• Time Zone: Select your time zone.
• Interval: Enter how often (in minutes) the system will sync with the NTP server.
• Manual Update: Manually update your system time using the NTP server.
• Click OK to save changes.
3. Click OK at the bottom of the General menu to save changes.
#; r. 2.0/23308/23308; en-US
26