Displaying And Setting The Water Hardness - Miele HG05 Operating Instructions Manual

Before using for the first time
Displaying and setting the water
hardness
 Open the door.
 Switch the dishwasher off with the 
button, if it is switched on.
 Press the programme selector button
 in, and whilst holding it in switch
the dishwasher on using the  but‐
ton.
Keep the programme selector button
 pressed in for at least four sec‐
onds until the lower right hand pro‐
gramme indicator comes on.
If this does not happen, start the proce‐
dure from the beginning again.
20
 Press the  button twice.
The  indicator will flash rapidly twice
at intervals.
The value set for the water hardness is
shown as a figure after  in the display
(see chart).
   will start flashing in the display.
This is the factory default setting of
15 °d.
 Use the programme selector button
 to select the value which equates
to your water hardness level.
Each press on the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
The setting is now stored in memory.
 Switch the dishwasher off with the 
button.