Table of Contents
Advertisement
Introduction
The Copywriter Flash Duplicator allows you to make fast copies of USB flash cards. This series
is available in 3, 7, or 11 copy configuration.
What's Included
When unpacking your Copywriter Flash Duplicator system, the following items should be
included:
•
Copywriter Flash Duplicator
•
Users Manual (this document) and Starter Kit
•
Power Cord
If any of these items are missing, please contact your distributor or Microboards Technology
Technical Support:
United States
PH: 952-556-1639
FAX: 952-556-1628
support@microboards.com
www.microboards.com
Please have the Model and Serial Number of your Copywriter Flash Duplicator available when
contacting Technical Support.
Installation
•
Connect the power cable to the Copywriter Flash Duplicator and plug in to a
protected power outlet strip or UPS power supply.
•
Turn on power to the duplicator.
•
The system will go through initialization and then display: 1. Copy.
•
The system is now ready to use.
Loading and Unloading Flash Cards
You should never unload any card that is in use by the duplicator. If the green LED above the
port is flashing, the card is in use.
USB Flash
To load USB flash cards, slide the card into the port. If it does not slide in easily, flip the USB
card over and try again.
To unload USB flash cards, simply pull them out of the port.
Europe
PH: +44 (0) 845 230 7800
www.microboards.co.uk
5
Japan
PH: 03-3561-2266
www.microboards.co.jp
Advertisement
Table of Contents
Need help?
Do you have a question about the Copywriter Flash Duplicator and is the answer not in the manual?
Questions and answers