Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for HDTV Supply HDTVHDM942U
Summary of Contents for HDTV Supply HDTVHDM942U
- Page 1 4 by 2 HDMI Matrix with Dual ARC Operation Manual...
-
Page 2: Package Contents
1. Introduction This is a high performance HDMI Matrix with four HDMI inputs & two outputs, it allows any source (Blue-Ray player, HD DVD player, satellite receiver, game system, etc.) to be shown on the any of the two displays simultaneously, and supports 4K×2K, 3D, 12-bit Deep Color. -
Page 3: Rear Panel
Dimensions 113 mm (W) × 260 mm (D) × 26 mm (H) Weight 750 g Chassis Material Metal Silkscreen Color Black Operating Temperature 0 °C~40 °C/ 32 °F~104 °F Storage Temperature −20 °C ~ 60 °C/−4 °F ~140 °F Relative Humidity 20~90 % RH (non-condensing) Power Consumption 2.0 W... -
Page 4: Connect And Operate
3. IR TX: Connect the IR Blaster cable included in the package for IR signal transmission. Pace the IR blaster in direct line-of-sight of the equipment to be controlled. 4. IR RX: Connect to the IR Receiver for IR signal reception. Ensure that remote being used is within the direct line-of-sight of the IR receiver. -
Page 5: Remote Control
IR BLASTER (TX) To control the source: Plug IR Blaster into IR TX port of transmitter unit; place blaster in front of the IR eye of the source. IR RECEIVER (RX) To control the source: Plug IR Receiver into IR RX port of receiver unit; place receiver at or near display. -
Page 6: Installation
7. PC controller user guide Installation The PC controller is green software. Just use a cable to connect the PC via RS232 port and copy “4x2 HDMI matrix Controller.exe” to PC to complete installation. Preparation 1. Connect PC and multi-viewer by RS232 cable (headers of both sides of cable should be FEMALE) 2. - Page 7 EDID Page The controller have 3 methods to set the EDID mode. Manual mode, Copy mode and open EDID file mode. Select the needed EDID to input port and click set button the EDID will write to the selected HDMI input ports. 2.
- Page 8 Matrix Page 1. LED which display Input number for respective Output 2. Click to select Input port for respective Output port 3. Click to select previous or next Input port for respective Output port 4. Click to open or close output ARC fuction...
- Page 9 Firmware Upgrade Page 1. Click to open FW file(file extension is “.fw”) 2. Click to upgrade the Matrix software 3. Display the message of the software upgrade process.
-
Page 10: Connection Diagram
8. Connection Diagram...