General Problems - Miele W 5903 WPS Operating Instructions Manual

Problem solving guide

General problems

Problem
The machine shakes
during the spin cycle.
The laundry has not
been spun properly and
is still wet.
The laundry has not
been spun satisfactorily.
The pump makes
strange noises.
Large amounts of
detergent residue remain
in the detergent
dispenser drawer.
Fabric conditioner is not
completely dispensed or
too much water remains
in the § compartment.
The display is in a
different language.
When laundry is dry, it
feels hard to the touch.
Power cut
44
Possible cause
The machine feet are not
level.
The machine detected an
imbalance during the final
spin and reduced the
spin speed automatically.
The spin speed selected
was too low.
This is not a fault! These noises occur at the end of
a pump sequence as a normal part of the operation.
The water pressure is too
low.
Powder detergent used
with water softeners can
be sticky.
The siphon tube is not
correctly positioned, or is
clogged up.
A different language has
been selected in
"Settings/ Language
Too vigorous wash
action.
Not enough detergent
used.
No fabric conditioner
used.
Once power has been restored to the appliance,
push the K button to continue the programme.
Remedy
Level the machine (see
"Installation").
Include both large and
small items in the load as
this will give better
distribution.
Select a higher spin
speed next time.
– Clean the filter in the
water inlet.
– Select Water plus.
Add washing powder
and then add the water
softener.
Clean the siphon, (see
"Cleaning and care -
Cleaning the detergent
dispenser drawer").
Set the language you
want. The flag symbol
". will guide you.
!
Programme in gentle
action and more water.
Increase detergent dose
to prevent limescale
build up in laundry.
Use fabric conditioner in
last rinse.