Advertisement
Advertisement
Related Manuals for Sunbeam Alpha SR6350
Summary of Contents for Sunbeam Alpha SR6350
- Page 1 SUNBEAM SR6350 ALPHA IRON User Guide SR6350 Sunbeam Alpha Iron...
-
Page 2: Table Of Contents
Contents Sunbeam’s Safety Precautions Features of your Sunbeam Iron Features of your Sunbeam Iron Using your Sunbeam Iron Care and Cleaning Ironing Chart... -
Page 3: Sunbeam's Safety Precautions
• Never leave an appliance unattended while in use. If you have any concerns regarding the performance and use of your appliance, Please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line. Ensure the above safety precautions are understood. -
Page 4: Features Of Your Sunbeam Iron
Features of your Sunbeam Iron Thermostat light Illuminates to indicate that the iron is heating and goes out when it has reached the selected temperature. The thermostat light cycles on and off during ironing as the iron maintains the selected temperature. - Page 5 Safety auto-off The iron automatically switches itself off if left in the ironing position (horizontal) for 30 seconds, or in the heel rest position (vertical) for 15 minutes. (For more information on the safety auto off feature see page 7). Temperature dial Allows you to select the desired temperature for each garment.
-
Page 6: Using Your Sunbeam Iron
¼ full of water. you to use tap water with your iron without affecting the steam performance. However in very hard water areas, Sunbeam recommends the use of distilled water, or water which has been demineralised. Do not fill the iron with fabric conditioner, starches or any other solution as these will damage the steam mechanism. - Page 7 Using your Sunbeam Iron (continued) Using the shot of steam NOTE: If the tank has run dry, it may be necessary to re-prime the pump after The shot of steam can be used whether filling the iron with water. dry or steam ironing when the temperature...
-
Page 8: Care And Cleaning
Care and Cleaning After each use Cleaning To clean the exterior of your iron, wipe 1. Turn the power off and remove the over with a damp soft cloth and wipe dry. plug from the power outlet. 2. Allow the iron to cool before winding Caution: Do not use harsh abrasives, the cord around the built-in cord wrap. - Page 9 Ironing Tips and Tricks Tip # 27 - Iron shirts like a pro Tip # 13 - Ironing the seam Start with the collar, working from the Always press seams in the same direction they were made. When a garment is outer edges into the middle.
-
Page 10: Ironing Chart
Ironing Chart Fabric Temp setting Ironing Ironing recommendation Acrylic Dry iron on reverse side of fabric • Dry iron on reverse side of fabric Acetate while still damp • Nylon Dry iron on reverse side of fabric • SYNTH Polyester Dry iron on reverse side of fabric •... - Page 11 2 year Year 2 years Australia www.sunbeam.com.au 1300 881 861 Units 5 & 6, 13 Lord Street, Botany NSW 2019 Australia New Zealand www.sunbeam.co.nz 0800 786 232 Level 6, Building 5, Central Park, 660-670 Great South Road, Greenlane, Auckland New Zealand...
- Page 12 Central Park, 660–670 Great South Road, Greenlane, Auckland. Sunbeam Corporation Limited | ABN 45 000 006 771 Sunbeam Corporation is a division of GUD Holdings Limited. CeraFlow is a trade mark of Sunbeam Corporation. Sunbeam Xpress is a trade mark of Sunbeam Corporation.