Manual Setup - LevelOne WCS-2040 User Manual

Installation wizard allows you to setup or upgrade multiple devices (of the same model) at the
same time. If you selected different models, then the buttons will be disabled. There are five
buttons on the bottom of the main page, and five buttons on the left panel of the main page.
Buttons
Click on this button to clean up the device list and search all devices on
the within the same subnet again. It will take about 5 seconds.
more detail, please refer to 0 Setup.
more detail, please refer to 0 Upgrade.
Click on this button to reset the selected devices to default settings.
Click on this button to get information about the Installation Wizard.

Manual Setup

When you select one device in the selection list, the "Manual Setup" button will be enabled.
Click on it to modify the settings of the selected device. After clicked on the "Manual Setup"
button, Installation Wizard would try to connect to the selected device.
The default Administrator's password is blank and the Network Camera initially will not ask for
any password. If the authentication is failed, there would be a pop-up dialog window to ask for
correct password. If you failed three times, the Installation Wizard would show you a warning
dialog window and abort the connecting to the selected device.
14 - User's Manual
Click on this button to modify the settings of the selected devices. For
Click on this button to upgrade the firmware of the selected devices. For
Authentication Dialog Window