Autofloat Switches - Maxum 2400 SE Sport Cruiser Owner's Manual Supplement

Chapter 6: Plumbing

Autofloat Switches

• The autofloat switches turn the bilge pumps On when water rises above a preset level.
• Test each autofloat switch often.
Autofloat switch testing:
1. Lift the autofloat switch test but-
ton to turn On the bilge pump.
• If the pump does not turn On, check
the fuse on the fuse block.
• If the fuse is good, but the switch
still does not work, it may mean the
switch is bad or, the battery is dead.
2. After testing, push the test button
all the way down to reset auto
mode.
When the test is completed on each float switch, you MUST push the test button ALL THE
WAY DOWN to reset auto mode!
32
LIFT TEST BUTTON UP
(BILGE PUMP SHOULD TURN ON)
!
CAUTION
AUTOFLOAT SWITCH
TESTING
TEST BUTTON
PUSH TEST BUTTON DOWN
(BILGE PUMP SHOULD TURN OFF)