After The Print - LeapFrog Xeed Manual

Leapfrog 3D Printers - Manual Xeed 26

2.6 After the print.

This section will explain what to do when your Xeed has finished the print job.
After the print you have to wait until the Xeed goes into its home position. It will home your x- and
y-axis and it will bring down your print bed, so it is easier for you to access your print. You can
open the doors and take your model off the print bed, you can also take out your print bed. This is
needed if the model is stuck to the bed. If you take out the print bed you can access your print
from more angles so it is possible to take off the model without damaging it.